| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| GD Longtail trailer position lock. Anyone make one? https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=6&t=64199 |
Page 1 of 1 |
| Author: | Bayport [ Sat Oct 17, 2015 6:11 am ] |
| Post subject: | GD Longtail trailer position lock. Anyone make one? |
I do not have the swivel bracket on mine so I tilt it, lay the handle against the seat and strap and bungee it to the boat for trailering. I'm trying to find a way to add something to the frame where it tilts to lock it in that tilted position and so it is not resting on the seat. Weld on something where I can insert a pin or something. Has anyone done this to a GD LT? Appreciate it. |
|
| Author: | flint87 [ Sat Oct 17, 2015 9:00 am ] |
| Post subject: | Re: GD Longtail trailer position lock. Anyone make one? |
Look up the godevil manual for your motor. They show how to tie it down for transport. Basically you want the motor to be able to rock back and forth so that the stress from bumps in the road doesn't go into your tiller handle or your transom. Sent from my iPhone using Tapatalk |
|
| Author: | Bayport [ Sat Oct 17, 2015 10:07 am ] |
| Post subject: | Re: GD Longtail trailer position lock. Anyone make one? |
Yea I have as shown Was just trying to find something easier Didn't think about the vibrations and such |
|
| Author: | KaCajun Boy [ Sat Oct 17, 2015 10:42 am ] |
| Post subject: | Re: GD Longtail trailer position lock. Anyone make one? |
2" ratchet strap with 1 loop around the handle hooked to the trailer and your good to go. |
|
| Author: | Bayport [ Sat Oct 17, 2015 11:01 am ] |
| Post subject: | Re: GD Longtail trailer position lock. Anyone make one? |
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|