| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| Beavertail motor change? https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=6&t=65380 |
Page 1 of 1 |
| Author: | sandybottoms [ Wed Jan 13, 2016 9:19 pm ] |
| Post subject: | Beavertail motor change? |
I picked up a beavertail 13hp with a Honda motor on a trade, I like it but it is a little underpowered for my boat. Question is, does anyone know what is the largest motor that I could replace the Honda with on that model frame, I realize I would have to re-prop it if I can get a bigger motor on that frame. But does anyone know if the 13hp frame will accommodate a 22+hp motor and everything just bolt up and go..? |
|
| Author: | huck Finn [ Wed Jan 13, 2016 9:38 pm ] |
| Post subject: | Re: Beavertail motor change? |
Start off by measuring output shaft diameter , to see what you have to match , keep in mind keyway thickness. Secondly measure output shaft height from base plate, center of shaft. You can then try to match as close as you can to clone motors . Specs are readily available online . If you find a match. , you'll next have to deal with base plate bolt layout . You can re tap and drill if need be . My originial godevil longtail, started as a. 9 hp crawfish , and ended up a 16 duromax, finally a 16. Vanguard. H Finn |
|
| Author: | sandybottoms [ Thu Jan 14, 2016 11:37 am ] |
| Post subject: | Re: Beavertail motor change? |
Thanks for the info |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|