| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| Shaft thickness https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=6&t=65726 |
Page 1 of 1 |
| Author: | DEbowhinter1 [ Tue Feb 09, 2016 5:25 pm ] |
| Post subject: | Shaft thickness |
So I'm pretty sure normal shaft thickness is schedule 80... But has anyone used 1" schedule 40 ridged pipe for your shaft housing? |
|
| Author: | flint87 [ Tue Feb 09, 2016 5:30 pm ] |
| Post subject: | Re: Shaft thickness |
I thought this thread was about something else. Carry on. Sent from my iPhone using Tapatalk |
|
| Author: | DEbowhinter1 [ Tue Feb 09, 2016 5:53 pm ] |
| Post subject: | Re: Shaft thickness |
Ahahahaha now that's funny I didn't even think of that before posting , guess I had that one coming |
|
| Author: | Mark F. Cheney [ Wed Feb 10, 2016 8:01 pm ] |
| Post subject: | Re: Shaft thickness |
I have seen a lot of motor frames made out of schedule 40 black iron pipe in the past. I see more and more dom tubing today Mark F. Cheney |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|