We run 50 yamahas on that size boat down here. You will be fine with a 23.
| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| need coonass input https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=6&t=9144 |
Page 1 of 1 |
| Author: | Woodiebuster [ Sat Apr 17, 2010 11:37 am ] |
| Post subject: | need coonass input |
i have a 1442 alumniweld and need a mudmotor, is a 23 horse go devil to much motor? some hunts i have to run the river for 20 miles so i need to scoot along pretty good but i dont want to much weight in the ass end of the boat what do yall think? |
|
| Author: | backwaterballer [ Sat Apr 17, 2010 12:43 pm ] |
| Post subject: | Re: need coonass input |
I run a 23 on a 14/48 with no problems. |
|
| Author: | mcnemar1982 [ Sat Apr 17, 2010 12:56 pm ] |
| Post subject: | Re: need coonass input |
We run 50 yamahas on that size boat down here. You will be fine with a 23.
|
|
| Author: | earl33 [ Sat Apr 17, 2010 1:04 pm ] |
| Post subject: | Re: need coonass input |
Do you want a LT or SD? 20 miles, aint there a closer ramp? If its similar to the rivers up this way then 23 hp LT up river = long trip.... |
|
| Author: | dead animal [ Sat Apr 17, 2010 2:36 pm ] |
| Post subject: | Re: need coonass input |
| Author: | cb5331 [ Sat Apr 17, 2010 5:23 pm ] |
| Post subject: | Re: need coonass input |
We tried putting a 24 on a 1442 and it damn near sunk it. With the motor and one person in the back to drive it, the top of the transom was about an inch or two out of the water. If you put a person in the front it would raise the back up a tad, but would just plow running wot. It plowed even worse with only one person. Impossible to plane out and water was comin over the back if you slowed down even a lil bit. That being said, a different 1442 may hold it up fine. Doubt it, but stranger things have happened. Also agree with DA. That boat is nothing to make a 20 mile run in. Get a big boat with a big outboard and carry a pirogue with you for when you make it to the skinny stuff. |
|
| Author: | DeathMetalDukk [ Sun May 09, 2010 8:24 am ] |
| Post subject: | Re: need coonass input |
Damn, that's a long trip. You're talking an hour or two, depending on how that thing runs. I'd get something bigger for sure. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|