It is currently Tue Jul 15, 2025 12:19 pm




Reply to topic  [ 2 posts ] 
 need info on greasing the mid section on a pro drive 
Author Message
MMT Pro Member

Joined: Wed Jun 19, 2013 2:25 am
Posts: 159
Post need info on greasing the mid section on a pro drive
ok well I greased the lower unit an a few other grease inserts an after a few pumps grease starts coming out some wheres..........but they have a grease inserts on the left top side of the midsection if ur looking at the muffler well I put probly 25 to 30 pumps of grease in it an grease dose not come out no wheres but it sounds like grease is coming out some times..............im wondering if i might have busted a seal


Sun Jun 23, 2013 7:18 pm
Profile
MMT Super Elite Member

Joined: Fri Dec 18, 2009 8:10 pm
Posts: 16915
Location: Rowlett, TX
Post Re: need info on greasing the mid section on a pro drive
The two zerks in the tower are just greasing the tower bushings. There is a lot of dead space in there so if there wasn't much grease in there, it will take quite a bit. It will come out in between the LU and the tower and up around the reverse plate when it's full. Put it in reverse, back to forward, and work the LU quite a bit when filling it up to make sure you get it worked in there good. No seals in there to worry about.


Sun Jun 23, 2013 8:13 pm
Profile
Display posts from previous:  Sort by  
Reply to topic   [ 2 posts ] 

Who is online

Users browsing this forum: No registered users and 43 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: