Got my hammer and throttle in today does anyone know what size to drill out the throttle to fit the gt Im being lazy this weekend with work and didnt feel like pulling the plastic one off.

20140328_172611.jpg20140328_172619.jpg

I'll be interested to hear what that prop'll do on your motor.


Sent from my iPhone using Tapatalk

Enjoy your MB stuff

I'll like to hear how the throttle install goes, kinda like the idea of the bps throttle over the gt

Yeah, how about a step by step.

Does yours have the hammer casting on other side? I ran mine shallow by myself two says ago, damn it had some low end. Ran well in deep aswell.

It's actually pretty easy but a drill bit isn't gonna do u any good u need a burring tool to burr it open


Sent from my iPhone using

Been seeing any numbers yet, Chris, or is it still too cold?


Sent from my iPhone using Tapatalk

The GT handle is 1 inch OD. It will be tough to drill because the hole on the BPS throttle lever clamp is at an angle. And its stainless. I just installed one a week ago and it took about 15-20 minutes to open the hole up with a high speed drill and a carbide bur.

But its a night and day difference than the plastic lever. It doesn't need a stronger spring either. it actually has less friction ( better geometry) than the plastic one as well and easier to do a cable change.

LOL You would like it, Its easier to squeeze and more comfortable.

20140331_124427.jpg
BB I did the install today and that thing is a night and day difference only problem I had is the cable that was sent to me isnt right the one on the right is what I got left is my cable on my motor. Dunno y one is so small.

How easy was that new throttle to install? I like the idea but want to make sure I can do it before I buy one.

I used it today for the first time running crawfish traps and man its really comfortable.

The hammer prop runs very well also does good in the lillies waters about 18" deep so never put in mud lost a lil speed ill bring gps next time and post the numbers

Used a 4 inch grinder with a buffing pad to fit mine, poor folks got poor ways!

Sent from my SAMSUNG-SGH-I537 using Tapatalk

are they out yet?

iI broke a couple plastic throttle levers also, finally went to local bike shop and bought a spring loaded rear brake lever and cable assemblly for a Schwin bike. They cut cable and housing to length for me and installed lever cable barrel on cable. Works great and spring in lever always brings cable back to Idle. Lever has cable adjuster bilt into it to adjust for stretch. Used a barrel style cable clamp at carb linkage.