Let's start another thread it's been a while ....


But on a serious note .. Has anyone tested one on a 25 ?? I could always have it pitched down if it's too much , but thinking it could help with a load

... Just looking for options I need a new prop and will just have the old 2 blade rebuilt for my hunting/mud prop

I'm waiting on an old one to have someone toy with.

Ah .. I would prefer a new and just re-pitch but don't even know of it's worth it

Have you ever tried a BB, I ran a worn one and it sucked, I could only spin it to around 3100. I seriously doubt you could run a 3 blade unless it was heavily modified.

But I'm far from knowledgable about props.....

But I know a guy!


Now one of these big motor guys need to run a three blade through some sand already.

I know a guy also .. Really well in fact and I used to work in his prop shop

No it's not gunna turn it stick to the 2 blade.

Yea you need some low end grunt for the 3blade...I know for sure if my 35 was stock it wouldnt have turned it good at all


Sent from my iPhone using Tapatalk

Speaking of said shop.... I just picked up some of his handiwork....

This thing was beat to shit, spun hub, and re pitched and re cupped.... Picked up MPH and tons of hole-shot on a heavy ass boat.

Txkingfisher was working on something for his small Copperhead a while back, wonder if something along the same lines can be done for the smaller Hp GT's

I may do what T said .. Wait for someone to burn up a 3 blade in the sand .. Run it see what happens .. So first wore 3 blade out there lemme know .. Cause always re add cup and reduce pitch ..

And make it just as shiny lol

You can have the second I been planning this since they hit the shelf lol

Ok #2 then