|
|
FAQ
• Login
|
|
It is currently Mon Jul 07, 2025 5:02 pm
|
|
Page 1 of 1
|
[ 4 posts ] |
|
| Author |
Message |
|
lagunaduck
MMT Member
Joined: Wed Feb 25, 2009 7:57 pm
Posts: 9
|
 Rewiring GD Boat Old GD boat wiring is getting brittle. I had to make a couple splices during last season and would like to replace the wiring. What gauge wiring do I need and how much? Any advice on this job?
|
| Fri Apr 10, 2009 4:05 pm |
|
|
|
Mudgun
MMT Addict
Joined: Wed Jan 14, 2009 12:24 pm
Posts: 746
Location: Here Be Rocks VA
|
Re: Rewiring GD Boat Scotchkote everything!
_________________
1660 Rhino High-Side with center console
90/65 Mercury 2 stroke Outboard jet pump
Run shallow, run loud.
|
| Fri Apr 10, 2009 5:00 pm |
|
|
|
deadbird8
MMT 1000 Club
Joined: Wed Feb 04, 2009 7:50 pm
Posts: 3833
Location: Old East Dallas, Texas
|
Re: Rewiring GD Boat Depends on the runs/where your battery is/what you run in the boat. 100W spots draw 8.3Amps, bilge pump- 2-4, running lights 1-2. If you control high amp stuff from a switch in the back, you may want to look at installing a relay.
Cover your connections with liquid electrical tape, if you add a piece of shrinkwrap over it you get a clean looking connection.
Check Mudd's site for spot wiring, may give you some ideas:
_________________
Excel 1851F4 w/ MB35HD+R CDI with a little bit of this and little bit of that
|
| Fri Apr 10, 2009 5:23 pm |
|
|
|
lagunaduck
MMT Member
Joined: Wed Feb 25, 2009 7:57 pm
Posts: 9
|
Re: Rewiring GD Boat Thanks for all the info. I don't have much accessories. I use a hand held spot light or hard hat light. So all I really have are the running lights.
|
| Sat Apr 11, 2009 8:18 pm |
|
|
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 87 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
