FAQ • Login
It is currently Mon May 12, 2025 4:31 pm




Reply to topic  Page 1 of 1
  [ 2 posts ] 
Print view Previous topic | Next topic 
 Prodrive users - Water in foot 
Author Message
oleman
MMT Member

Joined: Sun Sep 13, 2009 8:58 am
Posts: 49
Post Prodrive users - Water in foot
Looks like I got water in the foot again. Only 39 hours on the new lower seal. Is there an upper seal? I read in another topic about getting the foot machined at Prodrive to stop this. Has anyone got this done and did it stop the problem? If it did I will send it to Prodrive. Any instructions to drop the foot would be greatly appreciated.

THANKS in advance


You do not have the required permissions to view the files attached to this post.
_________________
16 x 48 Alweld - 36 PD FPR PT&T

Sun Sep 30, 2012 9:21 am
Profile
OwenDickeson
MMT Elite Member

Joined: Wed Mar 11, 2009 12:45 pm
Posts: 9869
Post Re: Prodrive users - Water in foot
Did you run the motor with the prop engaged before you checked the fluid?
Sun Sep 30, 2012 10:09 am
Profile
Display posts from previous:  Sort by  
Reply to topic   Page 1 of 1
  [ 2 posts ] 

Board index » MMT Main Forums » Props & Lower Units

All times are UTC - 6 hours


Who is online

Users browsing this forum: No registered users and 130 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: