I've got a non Cdi 35 and it has performance exhaust and twin mikuni carbs. It doesn't have a rev limiter and I can turn it 4450 rpm but I try not to run it over 4200 rpms. I was wondering if it would swing a hammer prop an drop me down to about 4200 rpms. I always have a load on my 1750 gtrx 3 or 4 people and with my worn big blade it won't plane out. Been wanting to do mods but money is pretty tight.

Sell them two carbs and put a single 42hsr. It will give you better bottom end. There is also a lot of motors turning 4400-4600rpms with no problems.

U can turn a hammer but it may drop u under 4200 if all u have is carbs

What la prop said