can u use FPR with a steering console? and if u can is it worth it to have to go back and turn it around?

they have hydralic reverse now, no more goin to back of the boat and pulling the pins

I heard both? a little on the pricey side but, Talk is cheap!

I have reverse on my console and it's a pain in the butt to get it into reverse. I plan to upgrade to the hydraulic as soon as it's available.

its reverse+700 =1200

thanks guys i think i might just pass on the reverse, too much money and trouble by the sounds of it, and its not really needed anyway

just get bayouboy to fab up one of his pin pullers and mount it on the console so you dont have to go to the motor and pull the pin down

I love my pin puller... Sure makes it mighty easy!

BB's deal is slick. Makes more sense for a tiller than the hydro and would be a ton cheaper to make/buy. The worst part of pulling the pin is turning around and bending over to reach it. But its still not as bad as it sounds either. Now if I could get Crews to send his to me since it don't fit his motor anyway I'd be happy. I ain't got BB's shop skilz.

I ain't gots a hook in this water ..... but ...... ifin' I was runnin' the Pro-Drive MudMotorMachineThang ......

BayouBoy's deal is the ticket !!!!!

We trying to get BB to market the thing. It would be a big sale.

Lets just say no more dirty or greasy hand or left pant leg!

I'll see if I can find the vid on it. it might still be in the camera.

Something like this??? I gotta change a few things on it. I like it alot!

how did you get one?

I made it.

you said you gotta change some things...does it work like it is or not?

It works alright! Some things are just a pain about it. IM gunna move that bolt (in the reverse plate) to the back side of the gizmo. See it interferes with that stainless bolt right below it.

Aluminum against aluminum=wear. And since i have some parts that touch each other to lower the fork, i have an idea on using a certain kind of material that wont need any kind of lube.

And there is one other thing i dont want to explain. But im working on it.

How you got the lever mounted to the handle? You find a lever to fit the 1.5" dia. handle or make something?

Nothing out there for 1.5 handle. I looked and looked and looked.... Then looked some more.

So i made it.

Only thing I saw was for custom harley bars but was a hydro clutch handle and $$$$$$$$$$$ as chit.

Yah i found those for bikes, but i couldnt justify spending the green. plus i couldnt think of any way to hydraulic-ly lower the pin.

Are you fukers lazy or what??? Just turn your ass around and pull the fuking pin already!!!!

If we ran clean water like you yankees and only had to use reverse a time or 2 on every outing that woud be ok.

Not to shabby grass hoppa

Here a pic of the proto type that T-crews has.

Mitsckee ~ I'm proud of ya !!! You somwhat
put the copy on a devise that someone else
invented ..... but you did do it !!

Good Job !!!

Pretty neat there. To make one Hyraulice would be awesome. But I doubt you will have anything that can pull the pin that far. I never seen it in person, but this looks pretty damned good. Hunter had told me about it and this will make alot of PD guys "faster at their FPR"

You boys got skillz to be making that shit

Gimme sum measurements I got the AutoCAD. Shazamm i can whip up something. At a small FEE?

I'd be willing to pay for one of em

Hey bb or mitschke, yall got a pic of the inside of that thing? Or a pic of what makes the fork pull down? Thinking about "trying" to make one. Key word "try"