Trim ain't workin too swiftly....real sluggish. Battery's good. Hyd fluid is low so I need to add- However it completely quit working...raised it enough to get the motor to tow mode...30 seconds later it's done. WTF???

Mess with the wires where they come out of the trim motor. Mine had to be rewired by PD. The wires were just a little to short and over time one broke from fatigue right at the rubber gromet where it goes into the housing.

Hopefully its just your wiring, a few of us down this way have been having issues with water getting inside the plastic motor housing. the field and armature were building up rust and making contact.

simple test, tap on the plastic motor housing with the handle of a screw driver while working the trim switch up and down. if it starts working more than likely you've got water in there. Its not hard to take apart. a 30 min job total to break it down, clean it up, and reassemble.

Do a search on here, there's a similiar thread on this topic with a lot more info.

cool....I'll give that a whirl-

Found my test light and I have power to the switch, power to the motor, everythings cool there-

I'll dik around with it a bit more.....worst part it....I was gonna make the run in Wallisville this morning in hopes of getting to hang out with gigadump again ...dayum the luck....next surprise visit instead I suppose

Trim problems?????????????


I think you are making that up so Giga don't beat your ass.




He sent me a PM the other day saying he hoped you showed cause he was going to go all MMA on your ass.

Yeah come on out TMAC I'm leaving now but got people showing up all the way till noon! Come on out when you get it fixed!

Here's the link Myboy.


viewtopic.php?f=2&t=3170&p=32383&hilit=pd+trim#p32383

sure seems like ive been hearin about alot of problems from these new trim units...although they seem to be minor...just doesnt seem like somethin i don't want to be fukin with at 4:30 in the morning...wish i could get the winch trim on my new motor like i had on the last one.......

Good deal T-boy!

Big Teee
My old fashoined hand cranker PD trim works great, never failed me either, just a shot or two twice a year with the grease gun is all it needs

Heell, I broke that too, ( my fault tho, I kept forgetting to loosen the little tention knob on top and buggered up the main threads, it still lasted me two years) I switched to the hydraulic so I could still hang out with the cool kids!

Some people are just rougher on there chit than others!