We are all joking man, we are all happy for this guy.

I had plenty of privileges growing up, but I do think he is lucky to receive this as a graduation present.

We are just giving him a hard time, he don't seem mad.

Nah it dont bother me at all. I've been around enough of these guys at rides to know their a lot of bark but no bite


But just saying... .ImageUploadedByTapatalk1425996657.796429.jpg

Not hating but you had better had made straight A's for that.

Straight A's is alittle difficult seeing how half of my classes dual credit college classes but i get by with A's and mid-high B's.

Then it is well deserved. If you barely skated through high school and would be on the tit for the rest of your life, then I'd have to bitch slap someone. Congrats. Should have bought a Sport V. LOL.

I try to now as it is, i took 5 kids out on youth weekend and they killed 11 birds and a hog between the 5 of em.
As well as took a few others through out the season. It may be more difficult to get birds but those are my favorite hunts hands down.

Haha thanks guys.
Got er bolted up today, shold be able to get a decent deep water review on the EFI tomarrow afternoon..Also i noticed this new motor as 4 pin holes for the trim instead of 3, on the 4th hole it bottoms out on the concrete before the trim pump bottoms out lol. Also, i've seen some of you guys with an easy pin rather than that stupid nut and bolt. Where can i find one of those? And with an easy pin Does it still need to go thru that metal sleve tube? Thanks ImageUploadedByTapatalk1426037662.155599.jpg

Congrats on the motor!


Sent from my iPhone using Tapatalk

That's Longtail digging territory... Should be able to dig outta most anything. I'd imagine reverse would be about as useless as tits on a boar though at that much angle unless you wanted just to see how far you could bury the ass end of the boat.

I'm curious what the difference in speed and load carrying will be.

I'll take delivery of basically the same hull and engine the end of this month. Except it will be on a GDSD frame.

The one thing i cant seem to figure out is the tiller length. The tiller on the GTR is several inches shorter than the tiller of the GD but the GTR once bolted up is closer to the grab bar..or feels so atleast. Dosent make any sense to me.

Motor/frame/ handle is set a few inches forward trying to distribute weight. GTR housing/belt drive/tail is heavier than Godevil..... Also GTR is longer from front of engine to back of housing


Sent from my iPhone using Tapatalk

Thank ya sir. Should have time this afternoon to run it

Haha i wont it went straight into the dry box. Got everything bolted and wired up. Fixin to head out to the lake now. I think it looks pretty slick on the Go Devil hull! ImageUploadedByTapatalk1426093218.371414.jpg

For the pin I just took the one that came on it out and stuck it in the bottom hole permanently. Then cut a piece of 3/8 stainless all thread put two nuts and washers on one end to pull it out easily then drilled a hole and put a cotter pin in. I didn't put any sleeve over the all thread just let it rest right on it, doesn't seem to causing any issues.

Looking forward to your review. I am expecting one of these motors in the next few weeks myself.

Heres a review on it, only ran it for about 2 hours but im beyond impressed with it.
viewtopic.php?f=5&t=60709