Anybody wanna talk about or show what there setups are with twin mudmotors

Your handle is twin lt. Sounds cool. Add pics please

Years ago, when GD introduced that twin setup, I always wondered how that would run. I started with a 18 HP GoDevil myself on a 1436 jon. I even bought the "emergency" start hub from Coco and managed to manually start that 18 when the battery died. Was a good motor, slow but sure. How's your rotator cuff??

These motors just hot put on this boat they were my bro in laws he got them on a custom 1860 godevil boat that setup was badass it had everything, but he got tired of not having reverse an bought a 50 HP Mercury so I got em for cheep with low hours

Ran twin 23's on a heavy boat for a long while. I thought they were a pain in the ass. I always swore a single big block would have been better. Maybe a little slower but lighter and less torque.

Sent from my SM-G900V using Tapatalk

Thats pretty dam cool.. I have never seen a set in person. How does it run?

Well I'm having to do a little adjust to the cavitation plates his boat had a 16in transom smooth bottom and mine has 20 in with a tunnel hull so at first they were kicking themselves out of the water an were hard to hold but now ive got em where they are perfect we added about 4in to the plate and turned it up at about a 75° angle, so they are easy to run now except I'm having trouble with the engines themselves I think it's just gas so I'm getting all new filters and separators and lines hopefully that will fix it

We used to run a Go-Devil 1856 with twin 23's, I'm trying to find some decent pics. The thing was a beast in every way. Pushed about 19 mph full or empty. Load didn't really matter. The rig was heavy, heavy, heavy, and the motors were a workout to control. We sold it because it was just too much for our needs.

Sent from my SM-N920R4 using Tapatalk

Both engines are on the same gas tank, and yea these motors go same speed with our without a load

Did y'all ever have problems with one motor starving for gas but not the same one every time, it changes back an forth which ever motor I crank last acts likes its starving for gas and when I rev them up an put them in water they bog down an kill themselves

Yea that's what I'm gonna try is seperate tanks and if tht dosent work then I'm gonna put a fuel pump on them too

We never had an issue with the twin tanks.

Sent from my SM-N920R4 using Tapatalk

Okay thanks I'm gonna try twin tanks

One tank, 2 separate fuel lines.


Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Bad ass what size produces

I ment to say what size prodrives

Anybody know of anyone in East Texas that can work on a an 18hp vanguard motor and get it done quick, its got all new fuel lines and filters, I think it's got something in carbs cause when I try to rev it up it Boggs down and dies

No


Sent from my iPhone using Tapatalk

Will c, near longview

Okay do you have his # by chance

Just holler at us anytime. 903 985 4247 we get on them and back to you pretty quick

Where y'all located at

Address sent